Penguin Chillers Water Chiller Accessory Package

ater Chiller Accessory Package (Penguin Chillers)

• Description
  
• Specifications
  
• Package

• Our Water Chiller Accessory Package comes with the necessary items to set up any of our standard water chilling units. Each package comes with a pump, tubing adapters and vinyl tubing.
  
  The Danner 9.5 is fine for most chiller setups. If the tubing lines run over 15-20 feet, you may want to consider getting the Danner 18.
  
  3/4" tubing is typical and will work fine with the 1/2HP or 1HP Chillers.
  
  – We don’t recommend using the pump externally – The face of the pump is delicate; We do not recommend using a fitting on the face side of the pump. There is a high likelihood that if a fitting is tightened to the face side of the pump, it will crack.
  
  – We don’t recommend this pump to be ran submersed for cold therapy. – Getting in the water with the pump is not recommended as it is not GFCI protected equipment and has a possibility of electrifying the water.
  
  Filter recommendation:
  Penguin Chillers Cold Therapy Replacement Filter (10" x 2.5", 50 Microns, Pleated)
  
  Filter housing recommendation:
  Geekpure 10-Inch Whole House Clear Filter Housing - 3/4"NPT Brass Port-Fit for 2.5" x 10" Filters

   

• Pump Size	Danner 9.5 (950gph), Danner 18 (1800gph)
  Vinyl Tubing	3/4" ID, 1" ID
  Tubing Length	15 ft, 25 ft, 35 ft, 45 ft

• Danner Mag Drive Pump of your choice.
  950GPH / 1800GPH
  
  Vinyl tubing – your choice of 3/4″ or 1″ (3/4" is typical)
  
  Tubing adapters for Chiller – 2 qty
  
  Tubing adapters for pump – 1 qty